Uji Kinerja Modul Pelatihan Motor Penunjang Mata Kuliah Mekatronika
DOI:
https://doi.org/10.36722/sst.v3i3.217Abstract
Abstrak – Teknis pemberian pulse width modulation (PWM) menjadi sangat penting terutama dalam pengendalian motor seperti pada motor direct current (motror DC), motor stepper maupun motor servo. Lebar pulsa duty cycle dalam satu perioda waktu  PWM akan menentukan tingkat keakuratan kecepatan maupun sudut. PWM diatur memggunakan program (assembly), kemudian kecepatanya diamati menggunakan alat ukur laser tachometer sedangkan tingkat kepersisian sudutnya diukur menggunakan pola kertas (template). Untuk mendapatkan performa independensi setiap motor, maka motor dikendalikan dan diujicobakan tanpa menggunakan beban (tidak ada uji torsi).
Â
Kata kunci- pulse width modulation mekatronika motor traineer.
Â
Abstract – the pulse width modulation (PWM) is especially inportant for motor controlling such as in DC motor, stepper motor and servo motor. The width of duty cycle in time period will determine speed and angle accurately. PWM wil be generated by using low level programm code of microcontroller (assembler), then speed of motor observed by laser tachometer and angle rotation observed by paper patern template. To get the performance independence of each motor, the motor is controlled and tested without the use of loads (no test of torque).
Â
Keywords – pulse width modulation motor traineer for mechatronic modules.
References
DC Motor Driver, http://www.alldatasheets._.com/L298.html, (Diakses pada 24 Sept 2015)
http://www.pbclinear.com/Download/DataSheet/Stepper-Motor-Support Document.pdf, (Diakses pada 25 Sept 2015).
Labcentre Electronic, Proteus design suite, product guide. Website retrieved from .http//www.labcenter.com, (Diakses pada 2 Sept 2015)
Lam Zi-Yi; Wong Sew-Kin.The design of DC motor driver for solar tracking applications.10th IEEE International Conference on Semiconductor Electronics (ICSE), 2012.
L. Xiaosheng, W. Yuqiang, H. Nantian & H. Yue, The Networked Virtual Test System for Servo Motor and Drive Based on LabVIEW, Proceeding IEEE 7th international conference on Power Electronics and Motion Control, 1-5, 2012
N. Greenough; C. C. Kung, A new high-efficiency stepper motor driver for old technology stepper motor,IEEE 25th Symposium on Fusion Engineering (SOFE), 2013.
S. Sharp, A. Wicks, A. Ordys & G. Collier, Modelling of a Pan and Tilt Servo System, Proceeding of IEEE International Conference on Control, 1-5, 2012
TowerPro SG-5010 Servo Specifications and Reviews, http://www.servodatabase.com/servo_ /servo/towerpro/sg-5010, (Diakses pada 25 September 2015).
Western Engineering Mechatronic Systems Engineering, http://www.eng.uwo.ca/under_graduate/programs/Mechatronic.html.2015. (Diakses pada 2 Sept 2015)
